Sunvac 4900

The SunVac 4900 Horizontal Form, Fill and Seal machine is a Mulit-Vac style machine where a rigid or soft tray is vacuum formed from the base web, product is inserted into the trays and then a top web is married and sealed to close the tray. The machine contains an AMACO DV-210 flexographic printer to print the top web with one color graphics.

The Machine is 7 meters long by 1.5 meter wide by 2.25 meters tall and is shipped in 4 sections wired for 208/240v three phase 50/60 cycles power ready to plug in. Can also be set up for 460V. Requires minimum 50 psi compressed air.

• Bottom Formable Web, any thermo-formable plastic, 495mm + 5 mm width, 80 kg per roll

• Top Web, Paper, Tyvek, Plastic, 480mm + 5 mm width, 25 kg per roll

• Nickle plated stainless steel carry chain clips with directional Bearings to prevent roll-back

• Package loading area 48” x 19”.

• Flying knife crosscutting or hydraulic die knife cutting for thicker films

• In line AMACO DV-210 flexographic one-color top sheet printer. Machine can be converted to run pre-printed top sheet by adding eye-spot reader.

• Machine indexing, 2 pre-settable speeds – Controlled by Magnetek GPD 333 frequency controller and driven by 1 ½ hp AC motor. Actual cycle speeds are dependent on materials and depth of tray but the general speeds are 7 and 9 cycles per minute.

• New control panel with Unitronics V350-35-T38 with Color Touchscreen PLC

• 5 Sets of tooling included. 5” x 7” 2 cavity, 5” x 5” 3 cavity, 5 1/4” x 3” 5 cavity, 4 7/8” x 2 3/4” 5 cavity and 5” x 7” shaped rigid tray 2 cavity.

• Trim waste collection by vacuum removal system

Previous full production usage – used to package wound care products (bandages, dressings, pads, rolls) of various sizes in both rigid tray and flexible tray configurations. Top sheets printed on line. Excellent condition. Machine was placed back in operation 2016 after refurbishment including new controls and run only for samples. Several sets of dies included (see list below).

Price As is Where is $33,000

BID on this item or ASK QUESTIONS

• 5 Sets of tooling included. 5” x 7” 2 cavity, 5” x 5” 3 cavity, 5 1/4” x 3” 5 cavity, 4 7/8” x 2 3/4” 5 cavity and 5” x 7” shaped rigid tray 2 cavity.